How can we produce high end color glass bottles?


Coloured glass bottles need a series of processes to be beautiful, and their production processes are as follows: 1, pre-processing section. The pretreatment part of glass bottle spraying includes pre stripping, main stripping and surface adjustment. If it is in the north, the temperature of the main part should not be too low, and it needs insulation. Otherwise, the treatment effect is not ideal; 2, preheating section. Before the pretreatment, it is necessary to enter the preheating section. It usually takes 8~10 minutes. The glass bottle should have a certain amount of waste heat when it reaches the powder injection room, in order to increase the adhesion of the powder; 3, the glass bottle purge section. If the technical requirements of the workpiece are relatively high, this section is essential, otherwise, if there is a lot of dust on the workpiece, there will be a lot of granular particles on the surface of the workpiece after processing, which reduces the quality of the workpiece; 4, the powder injection section. The most important part of this section is the technical problem of the powder sprout master. If you want to create good quality, you can still pay a skilled master for 5 or drying section. This section should pay attention to temperature and baking time, powder generally 180~200 degrees is better, depends on the material of the workpiece. And the drying furnace is not too far away from the powder chamber, generally 6 meters. The glass bottle also has the former way water treatment, the glass bottle specially needs to pay attention to is the sewage discharge question. As for the quality of the glass bottle spraying, it is related to the water treatment glass bottle, the surface cleaning of the workpiece, the electrical conductivity of the hook, the size of the gas, the amount of powder spray and the level of the operator.